ServicesGutter Repair
Gutter Repair in Summerville
Most gutter trouble starts small: a dripping corner, a run that sags after a heavy storm, a hanger working loose from the fascia. We find the cause, fix it properly and leave the gutter looking as tidy as the day it went up.

Repair first, when repair is the honest answer
A gutter system is only as good as its weakest joint. Aluminum expands and contracts every day, sealant dries out, and fasteners slowly back out of wood. Most of the time the gutter itself is still sound. What it needs is fresh sealant, new hangers or a corrected slope so water moves toward the exit point instead of pooling in the middle.
The person who comes out to look at your home is the same person you talk to until the job is done. They take photos, show you what they found and tell you plainly whether a repair will last. If the metal is corroded through, or the run has failed in several places, we will say so and walk you through what Gutter Installation would involve instead. You decide with the facts in front of you.
What a gutter repair visit covers
- Resealing seams and corners
- We scrape out old, cracked sealant at miters, end caps and joints, dry the surface and lay a fresh bead of gutter-grade sealant. A clean surface is what makes the new seal bond instead of peeling in a season.
- Re-securing loose gutters
- Old spike-and-ferrule fastening tends to work loose over time. We replace failing fasteners with hidden hangers screwed into solid wood, spaced closely enough to carry the weight of a full gutter.
- Correcting the pitch
- A gutter needs a slight, steady fall toward its outlet. When standing water or a mid-run overflow tells us the slope is off, we reset the hangers so the run drains the way it should.
- Replacing damaged sections
- A dented, split or crushed length can often be cut out and replaced with a matching section. We match profile and color as closely as the available material allows so the repair does not stand out.
- Checking the fascia behind it
- Leaks often soften the fascia board before anyone notices. We probe the wood where we fasten and tell you if any of it is too soft to hold a hanger, so nothing gets screwed into rot and hidden.
Signs your gutters need repair
Drips at the corners
Water running down the outside of a miter or end cap during rain almost always means the seal has failed. It is one of the simplest repairs we make.
A run that sags or pulls away
A visible dip or a gap between gutter and fascia means hangers have loosened. Left alone, the weight of standing water will pull the run down further.
Overflow in the middle of a run
If water spills over the front edge partway along, the pitch may be wrong and water is pooling. Pine needles and oak leaves can add to it, which is where Gutter Guards may help.
Stains, peeling paint or soft wood
Dark streaks on siding, peeling trim paint or a spongy fascia board point to water escaping behind the gutter. Catching it early keeps a gutter repair from turning into a carpentry job.
Puddles or washouts below the eaves
Soil eroding along the foundation or mulch washed out of a bed is often the first thing you notice. It usually traces back to a leak or overflow right above.
How the repair goes, start to finish
- 1
A conversation by phone
Describe the drip, sag or stain you have noticed and which side of the house it is on. We book a visit for a time that suits you, and you learn the name of the one person who will see your job through.
- 2
An on-site look and a written estimate
We inspect the gutters, fasteners and fascia, photograph the problem areas and give you a written estimate that lists each repair. If a section is not worth saving, the estimate says so.
- 3
The repair day
We set ladders with standoffs to keep weight off your gutters, protect plantings below and work section by section. If we uncover something unexpected, we stop and show you before doing anything outside the estimate.
- 4
Water test and cleanup
Once repairs are done we run water through the affected runs to confirm the seals hold and the slope drains. Old fasteners, sealant scraps and offcuts leave with us, and we walk the property with you before we go.

What shapes the cost of a gutter repair
Repair pricing depends on what we find, which is why we look before we quote. A single resealed corner is a very different job from re-hanging every run on a two-story home. Your written estimate breaks the work into line items so you can see exactly where the cost comes from.
- Number of problem spots
- One leaking joint takes far less time than a dozen failing seams spread around the house. We price the spots we find, not a blanket figure.
- Height and access
- Second-story eaves, steep roof pitches and tight side yards take more setup and more care. Ground-level runs over open lawn are quicker.
- Condition of the fascia
- Soft or decayed wood cannot grip a new hanger, so any damaged stretch of fascia gets replaced first. That brings some carpentry into the job, and you will see photos of the board before it appears on your estimate.
- Material and profile
- Standard K-style aluminum is easy to match. Half-round profiles, copper or older, discontinued colors can take more effort to source and fit.
Gutter repair questions
Something not covered here? (843) 948-5510
Is it worth repairing my gutters, or should I replace them?
If the metal is sound and the problems are seals, fasteners or slope, repair is usually the sensible choice. When corrosion has eaten through, or failures keep appearing along the whole system, replacement often costs less over time. We give you that answer straight, with photos, and only recommend new gutters when the condition calls for it.
How long does a typical repair take?
Many repairs are finished in a few hours. Larger jobs, such as re-hanging every run or replacing fascia first, can take most of a day. We tell you the expected timing when we give you the estimate.
Do I need to be home during the repair?
Not necessarily, since all the work happens outside. We do like to walk through the finished work with you, so we will arrange that at a time that suits you.
My gutters overflow during heavy summer storms. Is that a repair problem?
Sometimes. A wrong pitch, a sagging section or a partial blockage can all cause overflow, and those we can correct. Occasionally a gutter is simply undersized for the roof area it drains, and in that case we will explain the options rather than patch something that cannot keep up.
Can you match the color of my existing gutters?
In most cases we can come very close with standard aluminum colors. Gutters that have faded in the sun for years may show a slight difference next to new metal, and we will point that out before we start so there are no surprises.
Let us take a look at that leak
Tell us what you are seeing and we will arrange a visit, inspect the problem and give you a written estimate. We work in Summerville and nearby towns including Ladson, Goose Creek and North Charleston.